###
有色金属(冶炼部分):2012,(1):46-49
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
DTAB微乳液体系溶水性能研究
(西安建筑科技大学 冶金工程学院,陕西省冶金工程技术研究中心,西安 710055)
Study on Water Solubility of DTAB Microemulsion System
(School of Metallurgical Engineering, Xi’ an University of Architecture and Technology, Shaanxi Province Metallurgical Engineering and Technology Research Centre, Xi’an 710055, China)
摘要
图/表
参考文献
相似文献
本文已被:浏览 2740次   下载 25次
投稿时间:2011-06-10               网络发布日期:2011-12-30
中文摘要: 研究了阳离子表面活性剂DTAB与不同助表面活性剂、油相形成的微乳液体系的溶水能力,并考察了温度、pH对微乳液体系稳定性的影响。分别绘制了不同体系的拟三元相图。研究结果表明:当DTAB与正丁醇质量比为13∶7,(DTAB+正丁醇)与环己烷质量比为3∶1时,DTAB/正丁醇/环己烷/水微乳液体系具有较大的稳定区域,其最大溶水量在50%左右。该微乳液体系在温度低于80℃时,稳定区域受温度影响较小;pH对该体系稳定性影响不大。
中文关键词: DTAB微乳液  溶水量  拟三元相图
Abstract:The water solubility of microemulsion system composed of DTAB, different co-surfactant and oil was investigated. The effect of temperature, pH value on the stability of the systems was studied. The pseudo-ternary phase diagrams in quaternary microemulsion systems of DTAB were measured. The results show that when the mass ratio of DTAB to n-butyl alcohol is 13∶7, and the mass ratio of both DTAB and n-butyl alcohol to cyclohexane is 3∶1, the maximum water solubilizing capacity in DTAB/n-butyl alcohol/cyclohexane/water system is 50%. The influence of temperature below 80℃ and pH value on the stability of this system are negligible.
文章编号:     中图分类号:    文献标志码:
基金项目:西安市科技计划项目(CXY1020[5]);西安建筑科技大学青年基金项目(QN0613)
引用文本:
周军,兰新哲,宋永辉,邢相栋,吴雷.DTAB微乳液体系溶水性能研究[J].有色金属(冶炼部分),2012(1):46-49.
ZHOU Jun, LAN Xin-zhe, SONG Yong-hui, XING Xiang-dong, WU Lei.Study on Water Solubility of DTAB Microemulsion System[J].Nonferrous Metals (Extractive Metallurgy),2012(1):46-49.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号