本文已被:浏览 2144次 下载 2441次
投稿时间:2017-09-25 修订日期:2017-09-28 录用日期:2017-10-09 网络发布日期:2018-02-11
投稿时间:2017-09-25 修订日期:2017-09-28 录用日期:2017-10-09 网络发布日期:2018-02-11
中文摘要: 以锌冶炼过程产生的氧化锌烟尘为原料,采用微波硫酸化焙烧—水浸工艺提取铟。采用响应曲面法(RSM)对焙烧过程进行优化,以铟的浸出率为响应指标,选取焙烧温度、酸矿比、焙烧时间为考察因素,采用Box-Behnken Design(BBD)设计方案以三因素三水平设计试验,得出最优化的焙烧工艺条件,并获得拟合度高的二阶多项式模型。结果表明,微波硫酸焙烧氧化锌烟尘的最佳工艺条件为:焙烧温度208 ℃、酸矿比0.5(mL/g)、焙烧时间93 min;在最佳焙烧条件下,铟浸出率模型预测值为92.89%,试验真实值为92.78%,模型可用于预测微波硫酸化焙烧氧化锌烟尘提铟的工艺。
Abstract:Indium was leached from refractory zinc oxide flue dust (ZOFD) by microwave sulfating roasting followed by water leaching. Response Surface Methodology (RSM) was applied to optimize roasting process. The optimum process parameters and two order polynomial equation models with high fitting degree were obtained by three-factor at three-level test designed by Box-Behnken Design (BBD) applying indium leaching rate as response value, and roasting temperature, ratio of acid to ZOFD, and roasting time as independent factors. The results indicate that the theoretical indium leaching rate accords with model predicts and experimental value is 92.89% and 92.78% respectively under the optimum conditions including roasting temperature of 208 ℃, ratio of acid to ZOFD of 0.5 (mL/g), roasting and duration of 93 min. This model can be used to predict indium leaching from zinc oxide dust by microwave roasting with sulfuric acid.
keywords: zinc oxide dust microwave sulfate roasting indium leaching response surface methodology optimization
文章编号: 中图分类号:TF843 文献标志码:
基金项目:国家自然科学基金资助项目(51404081);云南省科技领军人才培养计划项目(2013HA002)
| 作者 | 单位 | |
| 常军* | 铜仁学院 材料与化学工程学院 | junchang85@163.com |
| 张利波 | 微波能工程应用及装备技术国家地方联合工程实验室 | |
| 彭金辉 | 微波能工程应用及装备技术国家地方联合工程实验室 | |
| 王万坤 | 贵州理工学院 材料与冶金工程学院 贵州理工学院 材料与冶金工程学院 |
| Author Name | Affiliation | |
| CHANG Jun | College of Material and Chemical Engineering,Tongren University | junchang85@163.com |
| ZHANG Li-bo | ||
| PENG Jin-hui | ||
| Wang wan-kun |
引用文本:
常军,张利波,彭金辉,王万坤.微波强化焙烧氧化锌烟尘提铟工艺优化研究[J].有色金属(冶炼部分),2018(3):39-44.
CHANG Jun,ZHANG Li-bo,PENG Jin-hui,Wang wan-kun.Optimization Extraction of Indium by Microwave Enhanced Roasting Process from Zinc Oxide Dust[J].Nonferrous Metals (Extractive Metallurgy),2018(3):39-44.
常军,张利波,彭金辉,王万坤.微波强化焙烧氧化锌烟尘提铟工艺优化研究[J].有色金属(冶炼部分),2018(3):39-44.
CHANG Jun,ZHANG Li-bo,PENG Jin-hui,Wang wan-kun.Optimization Extraction of Indium by Microwave Enhanced Roasting Process from Zinc Oxide Dust[J].Nonferrous Metals (Extractive Metallurgy),2018(3):39-44.

关注微信公众号