###
有色金属(冶炼部分):2018,(1):55-58
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
热重-差重分析法研究CeCl3的热分解过程
薛凯,伍永福
(内蒙古科技大学,内蒙古科技大学)
Study on Thermal Decomposition Process of CeCl3 by TG-DSC
xuekai and wuyongfu
(Inner Mongolia university of science and technology,)
摘要
图/表
参考文献
相似文献
本文已被:浏览 2026次   下载 1912次
投稿时间:2017-07-06     修订日期:2017-07-11     录用日期:2017-07-13     网络发布日期:2017-12-20
中文摘要: 根据物性测试设计CeCl3溶液雾化热解试验。进行了CeCl3热解动力学过程模拟与热重分析。TG-DSC结果表明,CeCl3溶液在115、153、170、200、250 ℃都发生了化学物理变化造成样品失重,580 ℃后CeCl3溶液转变为CeO2,并对分解速率和活化能进行比较,发现有氧气参与比无氧气参与的质量变化率更高,反应更容易进行,CeCl3溶液在热解过程中因为溶质水的存在温度低于110 ℃时质量变化率更高,反应活化能更低,CeCl3溶液受热分解的最佳温度为750 ℃。
中文关键词: 动力学  TG-DSC  雾化热解  分解速率
Abstract:Atomized pyrolysis experiment of CeCl3 solution was carried out based on physical test design of CeCl3 solution to simulate CeCl3 pyrolysis kinetics and thermogravimetry analysis. According to TG-DSC curves, weightlessness of CeCl3 solution occurred at 115, 153, 115, 200 and 250 ℃ respectively caused by change of chemical physics. CeCl3 solution translated into CeO2 after 580 ℃. Based on comparison between decomposition rate and activation energy, mass change rate with oxygen participation is higher and easier for reaction than that of without oxygen participation. CeCl3 solution has higher mass change rate and lower reaction activation energy due to existence of solute water during pyrolysis upon temperature of lower than 110 ℃. The optimum thermal decomposition temperature of CeCl3 solution is 750 ℃.
文章编号:     中图分类号:    文献标志码:
基金项目:国家自然科学基金资助项目(51274060);国家科技支撑计划项目(2012BAE01B02)
引用文本:
薛凯,董云芳,伍永福,刘中兴,吴文远,边雪.热重-差重分析法研究CeCl3的热分解过程[J].有色金属(冶炼部分),2018(1):55-58.
xuekai,董云芳,wuyongfu,LIU Zhong-xing,WU Wen-yuan,BIAN Xue.Study on Thermal Decomposition Process of CeCl3 by TG-DSC[J].Nonferrous Metals (Extractive Metallurgy),2018(1):55-58.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号