本文已被:浏览 1822次 下载 1864次
投稿时间:2016-05-31 修订日期:2016-06-02 录用日期:2016-06-06 网络发布日期:2016-10-21
投稿时间:2016-05-31 修订日期:2016-06-02 录用日期:2016-06-06 网络发布日期:2016-10-21
中文摘要: 采用萃取法从石煤高酸浸出液中优先萃取分离硫酸,考查还原剂用量、萃取剂浓度、萃取温度、萃取时间对硫酸萃取率的影响。结果表明,在还原剂亚硫酸钠用量2 g/L、萃取剂三异辛胺浓度40%、萃取温度25 ℃、萃取时间2 min、相比O/A=1/1的条件下,经4级萃取,浸出液中硫酸浓度由110 g/L降低至5.25 g/L,浸出液pH升高至2.3,可直接用于萃取钒。以60 ℃热水为反萃剂、O/A=1/3条件下,经5级反萃,99%以上的硫酸可被反萃出来。萃取过程无其它药剂消耗,有机相可循环使用,且回收的硫酸可再利用。
Abstract:Separation of residue sulfuric acid prior to vanadium extraction from acid leaching solution of stone coal was performed by solvent extraction. Effects of reductant sodium sulfite dosage, extractant tri-octyl amine concentration, temperature, and reaction duration on extraction rate of sulfuric acid were investigated. The results show that sulfuric acid concentration in leaching solution drops from 110 g/L to 5.25 g/L after four-stage extraction under the optimum conditions including sodium sulfite dosage of 2 g/L, tri-octyl amine concentration of 40%, temperature of 25 ℃, reaction duration of 2 min, and O/A=1/1. PH value of leaching solution reaching to 2.3 can be directly used in vanadium extraction. Stripping efficiency of sulfuric acid is 99% above after five-stage stripping with 60 ℃water as strip extractant at O/A=1/3. No additional agents are consumed in extraction process, the organic phase can be recycled and recovered sulfuric acid can be reused.
文章编号: 中图分类号:TQ031;TD983 文献标志码:
基金项目:“十二五”国家科技支撑计划项目(2015BAB03B05)
| 作者 | 单位 | |
| 杨晓 | 武汉理工大学 | yydbb925@126.com |
| 张一敏* | 武汉理工大学 | zym126135@126.com |
| Author Name | Affiliation | |
| Yang Xiao | School of Resources and Environmental Engineering,Wuhan University of Technology | yydbb925@126.com |
| Zhang Yimin | zym126135@126.com |
引用文本:
杨晓,张一敏.从石煤提钒酸浸液中萃取分离硫酸[J].有色金属(冶炼部分),2016(11):28-31.
Yang Xiao,Zhang Yimin.Solvent Extraction of Sulfuric Acid from Acid Leaching Solution of Stone Coal[J].Nonferrous Metals (Extractive Metallurgy),2016(11):28-31.
杨晓,张一敏.从石煤提钒酸浸液中萃取分离硫酸[J].有色金属(冶炼部分),2016(11):28-31.
Yang Xiao,Zhang Yimin.Solvent Extraction of Sulfuric Acid from Acid Leaching Solution of Stone Coal[J].Nonferrous Metals (Extractive Metallurgy),2016(11):28-31.

关注微信公众号