###
有色金属(冶炼部分):2016,(9):55-58
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
混合电镀污泥中铬铁的选择性分离工艺
袁文辉,徐志峰
(北京矿冶研究总院,江西理工大学)
electroplating sludge; chromium; iron; selective separation
Yuan Wenhui and Xu Zhifeng
(Beijing General Research Institute of Mining and Metallurgy,Beijing,)
摘要
图/表
参考文献
相似文献
本文已被:浏览 1980次   下载 1773次
投稿时间:2016-05-10     修订日期:2016-05-11     录用日期:2016-05-13     网络发布日期:2016-08-19
中文摘要: 提出了利用磷酸盐从还原预处理后的电镀污泥浸出液中优先分离铬的工艺,并从理论上证明了铬铁分离的可行性,探讨了磷酸钠用量、溶液初始pH、反应温度、保温时间对铬铁分离效果的影响。优化条件为:PO43-/Cr3+摩尔比1.1、溶液初始pH 2.0、反应温度80 ℃、保温时间60 min、搅拌转速400 r/min,铬和铁沉淀率分别为96.0%和0.68%,铬铁单级分离系数141.2。
中文关键词: 电镀污泥  铬  铁  选择性分离
Abstract:A new process of chromium selective extraction with phosphate from electroplating sludge leaching liquor after reduction pretreatment was proposed. The feasibility was theoretically proved. The effects of sodium phosphate dosage, initial pH value of solution, reaction temperature, and holding time on precipitation rate of chromium and iron were investigated. Precipitation rate of chromium and iron is 96.0% and 0.68% respectively with single-stage separation factor of chromium and iron of 141.2 under the optimum conditions including PO43-/Cr3 =1.1 (mol ratio), initial pH value of 2.0, reaction temperature of 80 ℃, holding time of 60 min, and stirring speed of 400 r/min.
文章编号:     中图分类号:    文献标志码:
基金项目:国家高技术研究发展计划(863计划)重大项目(2012AA06A110)
引用文本:
袁文辉,徐志峰.混合电镀污泥中铬铁的选择性分离工艺[J].有色金属(冶炼部分),2016(9):55-58.
Yuan Wenhui,Xu Zhifeng.electroplating sludge; chromium; iron; selective separation[J].Nonferrous Metals (Extractive Metallurgy),2016(9):55-58.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号