###
有色金属(冶炼部分):2015,(8):43-45
本文二维码信息
码上扫一扫!
高温合金酸浸渣氧化焙烧—碱浸工艺研究
吴永谦,吴贤,陈昆昆,张卜升,郭瑞,马光
(西北有色金属研究院,西北有色金属研究院,西北有色金属研究院,西北有色金属研究院,西北有色金属研究院,西北有色金属研究院)
Study on Oxygen Roasting and Alkali Leaching of Acid Leaching Slag of Waste Superalloy
WU Yong-qian,WU Xian,CHEN Kun-kun,ZHANG Bo-sheng,GUO Rui and MA Guang
(Northwest Institute of Non-ferrous Metal Research,,,,,)
摘要
图/表
参考文献
相似文献
本文已被:浏览 2707次   下载 2104次
投稿时间:2014-12-02     修订日期:2014-12-04     录用日期:2014-12-08     网络发布日期:2015-07-17
中文摘要: 采用氧化焙烧—碱浸工艺提取某废旧高温合金酸浸渣中的钨。考察了焙烧温度、焙烧时间、氢氧化钠浓度、浸出温度及浸出时间等对钨浸出率的影响。结果表明,在下述最佳工艺条件下,钨浸出率可达98%以上:焙烧温度700 ℃、焙烧时间60 min、氢氧化钠浓度160 g/L、浸出温度85 ℃、液固比3、浸出时间60 min。
中文关键词: 高温合金  焙烧  碱浸  钨
Abstract:Tungsten was recovered from acid leaching slag of waste superalloy by oxygen roasting and alkali leaching. The effects of roasting temperature, roasting time, NaOH concentration, leaching temperature, leaching time on tungsten leaching rate were investigated. The results show tungsten leaching rate is 98% above under the optimum conditions including roasting temperature of 700 ℃, roasting time of 60 min, NaOH concentration of 160 g/L, leaching temperature of 85 ℃, L/S=3︰1, and leaching time of 60 min.
文章编号:     中图分类号:    文献标志码:
基金项目:国家高技术研究发展计划(863计划)项目(2012AA063204)
引用文本:
吴永谦,吴贤,陈昆昆,张卜升,郭瑞,马光.高温合金酸浸渣氧化焙烧—碱浸工艺研究[J].有色金属(冶炼部分),2015(8):43-45.
WU Yong-qian,WU Xian,CHEN Kun-kun,ZHANG Bo-sheng,GUO Rui,MA Guang.Study on Oxygen Roasting and Alkali Leaching of Acid Leaching Slag of Waste Superalloy[J].Nonferrous Metals (Extractive Metallurgy),2015(8):43-45.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号