###
有色金属(冶炼部分):2014,(1):71-74
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
二氧化硅/二氧化钛复合材料合成条件对其处理含氰废水性能的影响
王平,杨静,史娟华,张亚莉
(山东理工大学 化学工程学院,山东理工大学 化学工程学院,山东理工大学 化学工程学院,山东理工大学 化学工程学院)
Effect of Synthesis Conditions of SiO2/TiO2 Composite on its Capacity to Treat Cyanide Wastewater
Wang ping,Yang jing,Shi juanhua and Zhang yali
(School of Chemical Engineering,Shandong University of Technology,,,)
摘要
图/表
参考文献
相似文献
本文已被:浏览 2714次   下载 3934次
投稿时间:2013-06-27     修订日期:2013-06-29     录用日期:2013-07-01     网络发布日期:2013-12-23
中文摘要: 以乙醇为有机溶剂,硅酸钠和钛酸丁酯为原料,采用凝胶溶胶法制取二氧化硅/二氧化钛复合催化吸附材料,并进行热重分析来表征。结果表明,最佳制备条件为:硅酸钠∶钛酸丁酯∶乙醇∶水=7∶5∶30∶20(体积比),pH=2,硅酸钠用量30 mL,继续搅拌时间4 h,焙烧温度450 ℃,焙烧时间2 h。此条件下制备的材料用于含氰废水处理,铜吸附量最大,氰分解率也最大。
Abstract:SiO2/TiO2 composite was produced by sol-gel method and characterized by TG test with ethanol as solvent, sodium silicate and butyl titanate as raw materials. The results show that the optimum conditions include volume ratio of sodium silicate, butyl titanate, ethanol, and water of 7∶5∶30∶20, pH=2, sodium silicate dosage of 30 mL, continuous string time of 4 h, roasting temperature of 450 ℃, and roasting time of 2 h. With the composite, copper is well adsorbed and cyanide is well separated from wastewater.
文章编号:     中图分类号:    文献标志码:
基金项目:山东省自然科学基金项目(ZR2010EL006);山东省高等学校科技计划项目(Z12LA04)
引用文本:
王平,杨静,史娟华,张亚莉.二氧化硅/二氧化钛复合材料合成条件对其处理含氰废水性能的影响[J].有色金属(冶炼部分),2014(1):71-74.
Wang ping,Yang jing,Shi juanhua,Zhang yali.Effect of Synthesis Conditions of SiO2/TiO2 Composite on its Capacity to Treat Cyanide Wastewater[J].Nonferrous Metals (Extractive Metallurgy),2014(1):71-74.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号