###
DOI:
有色金属(冶炼部分):2018,(2):50-53
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
铜阳极泥二次预处理工艺优化研究
(贵溪冶炼厂冶金化工研究所)
Optimization of Secondary Pretreatment Process of Copper Anodized Mud
(Institute of Metallurgy and Chemical Engineering, Guixi Smelter, Guixi 335424, Jiangxi, China)
摘要
图/表
参考文献
相似文献
本文已被:浏览 2075次   下载 2214次
              网络发布日期:2018-01-22
中文摘要: 在铜阳极泥一次预处理脱铜、砷的试验基础上,研究了二次预处理脱锑、铋,同时避免碲分散的工艺。结果表明,在温度75 ℃、初酸浓度290 g/L(以硫酸计)、初始Cl-浓度150 g/L、反应时间3 h、液固比4︰1、用SO2 控制反应电位的条件下,锑浸出率为96.93%,铋浸出率为95.79%,碲可全部留在预处理渣中。
中文关键词: 铜阳极泥  二次预处理  锑  铋  碲  分散
Abstract:Based on pretreatment experiment to remove copper and arsenic from anode mud, secondary pretreatment to remove antimony and bismuth was studied without dispersion of tellurium. The results show that leaching rate of antimony and bismuth is 96.93% and 95.79% respectively with tellurium left in pretreatment slag under the optimum conditions including temperature of 75 ℃, concentration of primary acid of 290 g/L (in sulfuric acid), initial Cl- concentration of 150 g/L, reaction time of 3 h, L/S=4︰1, and reaction potential is controlled by SO2.
文章编号:     中图分类号:doi:10.3969/j.issn.1007-7545.2018.02.013    文献标志码:
基金项目:
引用文本:
蒋震清.铜阳极泥二次预处理工艺优化研究[J].有色金属(冶炼部分),2018(2):50-53.
JIANG Zhen-qing.Optimization of Secondary Pretreatment Process of Copper Anodized Mud[J].Nonferrous Metals (Extractive Metallurgy),2018(2):50-53.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号