###
有色金属(冶炼部分):2011,(12):15-17
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
M5640+P204+P507萃取净化镍电解液
(云南锡业集团(控股)有限责任公司研究设计院)
Nickel Sulphate Electrolyte Extraction Purified by M5640+P204+P507
(Institute of Research & Designing of YTC, Gejiu 661000, Yunnan, China)
摘要
图/表
参考文献
相似文献
本文已被:浏览 2954次   下载 36次
投稿时间:2011-07-04               网络发布日期:2011-12-06
中文摘要: 对硫酸镍电解液的萃取净化除杂进行了系统研究。采用M5640对铜离子进行除杂的条件为:pH3.0,相比1∶1,萃取剂体积浓度15%,振荡时间5 min,在此条件下铜离子的萃取率大于99.83%,萃余液含铜已达到5N镍电解液标准要求。去除铜离子之后,采用P204对电解液进行除杂,试验条件:pH4.0,相比2∶1,萃取剂体积浓度25%,振荡时间7 min,温度20 ℃。萃余液再用P507萃取除杂,试验条件:用氢氧化钠溶液均相制皂75%,提高待萃液当中钴离子的含量至4.19 g/L,即Co/Ni为1/10,4级萃取,控制水相pH 4~5。最终萃余液中各杂质离子的含量均达到生产5N镍的电解液标准。
中文关键词: 镍电解液  萃取  M5640  P204  P507
Abstract:The extraction purification of nickel sulphate electrolyte was studied. M5640 was used to remove Cu2+. The extraction rate was higher than 99.83% and the content of Cu2+ as lower than 0.1 mg/L on the conditions including pH =3.0, O/A=1/1, volume concentration of M5640 to be 15%, and the reaction time as 2 min. Then, P204 was used to remove other impurities. The conditions included pH =4.0, O/A=2/1, volume concentration of P204 to be 25%, and reaction time as 7 min. At last, raffinate was purified with P507 on the following conditions that 75% P507 was saponificated by sodium hydroxide solution, the concentration of Co2+ was increased to 4.19 g/L (Co/Ni=1/10), pH=4~5 and extraction series was 4. The final raffinate can satisfied the standard of 5N nickel.
keywords: Nickel electrolyte  Extraction  M5640  P204  P507
文章编号:     中图分类号:    文献标志码:
基金项目:
引用文本:
李学鹏.M5640+P204+P507萃取净化镍电解液[J].有色金属(冶炼部分),2011(12):15-17.
LI Xue-peng.Nickel Sulphate Electrolyte Extraction Purified by M5640+P204+P507[J].Nonferrous Metals (Extractive Metallurgy),2011(12):15-17.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号