###
有色金属(冶炼部分):2011,(5):52-55
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
钽合金零件冷摆碾成形组织性能研究
(北京有色金属研究总院有色金属加工工程研究中心)
Microstructure and Mechanical Properties of Ta-W Alloy Part Formed by Cold Rotary Forging
(Engineering Research Center for Non-ferrous Metals Forming, General Research Institute for Nonferrous Metals)
摘要
图/表
参考文献
相似文献
本文已被:浏览 3137次   下载 25次
投稿时间:2011-02-01               
中文摘要: 通过合理控制冷摆碾成形工艺参数,成功制备出形状尺寸满足要求、表面质量良好的钽合金薄壁回转体零件,研究了冷变形后钽合金的再结晶退火工艺,检测了退火后钽合金零件的力学性能和硬度分布,观察了径向不同位置的显微组织。结果表明,经过1 350 ℃×60 min真空退火,钽合金发生了完全再结晶,平均晶粒尺寸50 μm左右,零件不同位置的组织均匀性较好,抗拉强度达到360 MPa,延伸率45.5%。
中文关键词: 钽合金  摆碾成形  硬度  显微组织
Abstract:Tantalum alloy thin-walled rotating part with qualified size and good surface quality could be obtained through the reasonable control of rotary forging processing parameters. The recrystallization annealing process of cold-forming tantalum alloy was studied, the mechanical property and hardness distribution was checked, the microstructure of the part annealed was observed. The results show that tantalum alloy part annealed by 1 350 ℃×60 min is fully recrystallized, the average grain size is about 50μm;The tantalum alloy part possesses good uniformity microstructure, and tensile strength is 360 MPa, elongation rate is 45.5%.
文章编号:     中图分类号:    文献标志码:
基金项目:
引用文本:
李祥,李彦利,李德富,闫晓东,彭海健.钽合金零件冷摆碾成形组织性能研究[J].有色金属(冶炼部分),2011(5):52-55.
LI Xiang,LI Yan-li,LI De-fu,YAN Xiao-dong,PENG Hai-jian.Microstructure and Mechanical Properties of Ta-W Alloy Part Formed by Cold Rotary Forging[J].Nonferrous Metals (Extractive Metallurgy),2011(5):52-55.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号