###
有色金属(冶炼部分):2011,(1):41-44
←前一篇   |   后一篇→
本文二维码信息
码上扫一扫!
高速雾化分解法制取活性氧化锌的研究
(1.中南大学冶金科学与工程学院;2.江西理工大学材料与化学工程学院)
Preparation of Active Zinc Oxide by High-Speed Atomization
(1.School of Metallurgical Science and Engineering, Central South University;2.School of Materials and Chemical Engineering, Jiangxi University of Science and Technology)
摘要
图/表
参考文献
相似文献
本文已被:浏览 2477次   下载 33次
投稿时间:2010-03-05               
中文摘要: 研究了用高速雾化分解法由锌焙砂制备活性氧化锌的工艺。结果表明,锌焙砂经碳酸氢铵、氨水与水浸取液浸取,浸取率为98.48%。浸取液中的氧化锌含量可达25.3%(质量分数),用锌粉除杂净化,过滤除去杂质。滤液在喷雾干燥塔430 ℃的入口温度下喷雾热分解,可得到高活性的氧化锌。其吸碘值为42.445 mg/g,活性显著高于蒸氨煅烧法所得的氧化锌。
Abstract:The preparation of active zinc oxide by high-speed atomization decomposing method from a low-grade zinc oxide ore was studied.The low-grade ore was leached by NH4HCO3, NH3·H2O and H2O. The leaching efficiency was 98.48% and the ZnO content in the leaching solution was up to 25.3%. The impurity of leaching solution was precipitated by zinc powder and filtered. Then the filtrate was injected into a spray drying tower at entrance temperature 430 ℃. It can generate highly active zinc oxide. The iodine-absorbed quantity of active zinc oxide prepared was 42.445 mg/g and much higher than that of the other preparation method.
文章编号:     中图分类号:    文献标志码:
基金项目:
引用文本:
张志兵,石西昌,刘建华.高速雾化分解法制取活性氧化锌的研究[J].有色金属(冶炼部分),2011(1):41-44.
ZHANG Zhi-bing,SHI Xi-chang,LIU Jian-hua.Preparation of Active Zinc Oxide by High-Speed Atomization[J].Nonferrous Metals (Extractive Metallurgy),2011(1):41-44.

我们一直在努力打
造,精品期刊,传
播学术成果

全国咨询服务热线
86-10-63299752/63299758

联系我们

电话:010-63299752/63299758

传真:010-63299744

QQ:XXXXXXX

Email:ysyl@bgrimm.com

邮编:100160

地址:北京市南四环西路188号总部基地18区23号楼

关注微信公众号